Average Reviews:
(More customer reviews)It is not T-track, but it is a very well made, thick wall, t-slot miter track.
First, some definitions:
T-track is designed to hold the head of a 1/4" bolt or special "T" bolts. The opening is appx. 1/4" for the shaft of the bolt to stick out of.
Miter track is designed for a 3/4" wide X 3/8" thick miter gauge rail (as found on table saws and band saws) to slide in. Some miter track also has a 15/16" wide bottom to accept miter gauge rails that have a wider bottom. This prevents the miter gauge from lifting out of the track in use. That is the way this miter track is made, so in the picture, it looks like T-track.
But this is a track for a 3/4" x 3/8" miter gauge. It is 1 7/32" wide X 1/2" tall. If you buy it based on the description and the picture you will think it is the smaller (usually 3/4" wide X 1/2" tall) T-track.
Again, it is very well made miter track. It is thicker than other aluminum miter track I have used, so I will keep it for later use, but I thought I was ordering T-track, which is what I needed. I hope this helps others from making the same mistake I did.
Click Here to see more reviews about: Big Horn 19802 48-Inch Aluminum T-Track
Click here for more information about Big Horn 19802 48-Inch Aluminum T-Track
No comments:
Post a Comment